What To Do After Conveyor Belt Joint Breaks
Date：2024-08-27 09:34:55 Browse :The conveyor belt joint breaks, nothing more than the following points:
1. The roller diameter of the conveying equipment is too small, causing the bending stress generated by the conveyor belt when it bypasses the roller to increase.
2. The conveying equipment starts and stops frequently, resulting in high tension.
3. The quality of the conveyor belt's heat flow joint is poor, especially after more than two heat flows, when the strength of the joint decreases.
What should I do if the conveyor belt joint breaks?
1. Mechanical joints connect the conveyor belt using steel buckles, rivets, clamps, etc. This joint method is convenient, fast, and relatively economical, but the joint efficiency is low, it is easy to damage, and not all equipment is suitable for this type of conveyor belt connection method.
2. Cold bonding joints connect the conveyor belts with cold adhesives. This joint method is more efficient and economical than mechanical joints, and its effect is better than mechanical joints', but its process conditions are more difficult to master. In addition, the quality of the adhesive has a great impact on the joint, so it is not very stable.
3. Hot vulcanized joints connect the conveyor belts by heating and hot melting. This joint has a good effect, high strength, and good flatness. However, its process is cumbersome and expensive, and the joint operation time is long.
The above are some treatment methods for broken conveyor belt joints. If you want an economical one, you can choose mechanical joints and cold bonding joints. However, as a professional conveyor belt manufacturer, we are still optimistic about hot vulcanized joints. Although their process is cumbersome and expensive, and the joint operation time is long, they are the most stable of the three joint methods.
